Prof. Dr. AHMET NEDİM ERASLAN

ZAMM-ZEITSCHRIFT FUR ANGEWANDTE MATHEMATIK UND MECHANIK , cilt.97, sa.3, ss.340-357, 2017 (SCI-Expanded)

Analytical solution to thermal loading and unloading of a cylinder subjected to periodic surface heating

JOURNAL OF THERMAL STRESSES , cilt.39, sa.8, ss.928-941, 2016 (SCI-Expanded)

Bending of graded curved bars at elastic limits and beyond

ARSLAN E., ERASLAN A. N.

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES , cilt.50, sa.5, ss.806-814, 2013 (SCI-Expanded)

Amendments on "Application of Mises yield criterion to rotating solid disk problem" by N. Aleksandrova [Int. J. Eng. Sci. 51 (2012) 333-337]

INTERNATIONAL JOURNAL OF ENGINEERING SCIENCE , cilt.56, ss.127-128, 2012 (SCI-Expanded)

The rotating elastic-plastic hollow shaft conveying a hot medium

Arslan E., Mack W., ERASLAN A. N.

FORSCHUNG IM INGENIEURWESEN-ENGINEERING RESEARCH , cilt.74, sa.1, ss.27-39, 2010 (SCI-Expanded)

Analytical solution to the bending of a nonlinearly hardening wide curved bar

Arslan E., ERASLAN A. N.

ACTA MECHANICA , cilt.210, ss.71-84, 2010 (SCI-Expanded)

ELASTIC-PLASTIC STRESS ANALYSIS OF NONHOMOGENEOUS ROTATING SOLID DISCS

ERASLAN A. N., APATAY T., Gulgec M.

JOURNAL OF THE FACULTY OF ENGINEERING AND ARCHITECTURE OF GAZI UNIVERSITY , cilt.23, sa.3, ss.627-635, 2008 (SCI-Expanded)

Discussion of the article "Approximate solution of limit angular speed for externally loaded rotating solid disk" by S. Bhowmick, D. Misra and NK Saha [Int J Mech Sci 2008;50:163-74]

ERASLAN A. N., TOKDEMİR T.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES , cilt.50, sa.9, ss.1432-1433, 2008 (SCI-Expanded)

A concise analytical treatment of elastic-plastic bending of a strain hardening curved beam

ERASLAN A. N., Arslan E.

ZAMM-ZEITSCHRIFT FUR ANGEWANDTE MATHEMATIK UND MECHANIK , cilt.88, sa.8, ss.600-616, 2008 (SCI-Expanded)

Thermoelastic response of a fin exhibiting elliptic thickness profile: An analtical solution

INTERNATIONAL JOURNAL OF THERMAL SCIENCES , cilt.47, sa.3, ss.274-281, 2008 (SCI-Expanded)

On the use of temperature-dependent physical properties in thermomechanical calculations for solid and hollow cylinders

Argeso H., ERASLAN A. N.

INTERNATIONAL JOURNAL OF THERMAL SCIENCES , cilt.47, sa.2, ss.136-146, 2008 (SCI-Expanded)

Effect of a temperature cycle on a rotating elastic-plastic shaft

ARSLAN E., Mack W., ERASLAN A. N.

ACTA MECHANICA , cilt.195, ss.129-140, 2008 (SCI-Expanded)

The strain hardening rotating hollow shaft subject to a positive temperature gradient

Eraslan A. N., Arslan E., Mack W.

ACTA MECHANICA , cilt.194, ss.191-211, 2007 (SCI-Expanded)

Exact solution of rotating FGM shaft problem in the elastoplastic state of stress

Akis T., Eraslan A. N.

ARCHIVE OF APPLIED MECHANICS , cilt.77, sa.10, ss.745-765, 2007 (SCI-Expanded)

Stresses in FGM pressure tubes under non-uniform temperature distribution

Eraslan A. N.

STRUCTURAL ENGINEERING AND MECHANICS , cilt.26, sa.4, ss.393-408, 2007 (SCI-Expanded)

Heat and mass transfer mechanisms in drying of a suspension droplet: A new computational model

Dalmaz N., Ozbelge H. O., Eraslan A. N., Uludag Y.

DRYING TECHNOLOGY , cilt.25, ss.391-400, 2007 (SCI-Expanded)

The stress response and onset of yield of rotating FGM hollow shafts

Akis T., Eraslan A. N.

ACTA MECHANICA , cilt.187, ss.169-187, 2006 (SCI-Expanded)

Plane strain analytical solutions for a functionally graded elastic-plastic pressurized tube

Eraslan A. N., Akis T.

INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING , cilt.83, sa.9, ss.635-644, 2006 (SCI-Expanded)

The stress response of partially plastic rotating FGM hollow shafts: Analytical treatment for axially constrained ends

Eraslan A. N., Akis T.

MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES , cilt.34, sa.3, ss.241-260, 2006 (SCI-Expanded)

On the plane strain and plane stress solutions of functionally graded rotating solid shaft and solid disk problems

Eraslan A., Akis T.

ACTA MECHANICA , cilt.181, ss.43-63, 2006 (SCI-Expanded)

Yielding of two-layer shrink-fitted composite tubes subject to radial pressure

Eraslan A., Akis T.

FORSCHUNG IM INGENIEURWESEN-ENGINEERING RESEARCH , cilt.69, sa.4, ss.187-196, 2005 (SCI-Expanded)

Stress distributions in cooling fins of variable thickness with and without rotation

Eraslan A., Kartal M.

JOURNAL OF THERMAL STRESSES , cilt.28, sa.8, ss.861-883, 2005 (SCI-Expanded)

Elastoplastic analysis of nonlinearly hardening variable thickness annular disks under external pressure

Eraslan A., Orcan Y., Guven U.

MECHANICS RESEARCH COMMUNICATIONS , cilt.32, sa.3, ss.306-315, 2005 (SCI-Expanded)

Stress distributions in elastic-plastic rotating disks with elliptical thickness profiles using Tresca and von Mises criteria

ZAMM-ZEITSCHRIFT FUR ANGEWANDTE MATHEMATIK UND MECHANIK , cilt.85, sa.4, ss.252-266, 2005 (SCI-Expanded)

A computational procedure for estimating residual stresses and secondary plastic flow limits in nonlinearly strain hardening rotating shafts

Eraslan A., Mack W.

FORSCHUNG IM INGENIEURWESEN-ENGINEERING RESEARCH , cilt.69, sa.2, ss.65-75, 2005 (SCI-Expanded)

Tresca's yield criterion and linearly hardening rotating solid disks having hyperbolic profiles

FORSCHUNG IM INGENIEURWESEN-ENGINEERING RESEARCH , cilt.69, sa.1, ss.17-28, 2004 (SCI-Expanded)

Thermoplastic response of a linearly hardening cylinder subjected to nonuniform heat source and convective boundary condition

MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES , cilt.32, sa.2, ss.133-164, 2004 (SCI-Expanded)

Von Mises' yield criterion and nonlinearly hardening rotating shafts

ACTA MECHANICA , cilt.168, ss.129-144, 2004 (SCI-Expanded)

On annular disks of variable thickness subjected to external pressure

Eraslan A., Apatay T.

FORSCHUNG IM INGENIEURWESEN-ENGINEERING RESEARCH , cilt.68, sa.3, ss.133-138, 2004 (SCI-Expanded)

Elastoplastic deformations of rotating parabolic solid disks using Tresca's yield criterion

EUROPEAN JOURNAL OF MECHANICS A-SOLIDS , cilt.22, sa.6, ss.861-874, 2003 (SCI-Expanded)

On the elastic-plastic deformation of a rotating disk subjected to a radial temperature gradient

Eraslan A., Akis T.

MECHANICS BASED DESIGN OF STRUCTURES AND MACHINES , cilt.31, sa.4, ss.529-561, 2003 (SCI-Expanded)

Assessment of flow and heat transfer characteristics for proposed solid density distributions in dilute laminar slurry upflows through a concentric annulus

Eraslan A., Ozbelge T.

CHEMICAL ENGINEERING SCIENCE , cilt.58, sa.17, ss.4055-4069, 2003 (SCI-Expanded)

Stress distributions in energy generating two-layer tubes subjected to free and radially constrained boundary conditions

Eraslan A., Sener E., Argeso H.

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES , cilt.45, sa.3, ss.469-496, 2003 (SCI-Expanded)

On the linearly hardening rotating solid shaft

EUROPEAN JOURNAL OF MECHANICS A-SOLIDS , cilt.22, sa.2, ss.295-307, 2003 (SCI-Expanded)

Thermally induced deformations of composite tubes subjected to a nonuniform heat source

JOURNAL OF THERMAL STRESSES , cilt.26, sa.2, ss.167-193, 2003 (SCI-Expanded)

Von mises yield criterion and nonlinearly hardening variable thickness rotating annular disks with rigid inclusion

MECHANICS RESEARCH COMMUNICATIONS , cilt.29, sa.5, ss.339-350, 2002 (SCI-Expanded)

On the rotating elastic-plastic solid disks of variable thickness having concave profiles

INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES , cilt.44, sa.7, ss.1445-1466, 2002 (SCI-Expanded)

Elastic-plastic stresses in linearly hardening rotating solid disks of variable thickness

Orcan Y., Eraslan A.

MECHANICS RESEARCH COMMUNICATIONS , cilt.29, sa.4, ss.269-281, 2002 (SCI-Expanded)

Elastic-plastic deformation of a rotating solid disk of exponentially varying thickness

MECHANICS OF MATERIALS , cilt.34, sa.7, ss.423-432, 2002 (SCI-Expanded)

Computation of transient thermal stresses in elastic-plastic tubes: Effect of coupling and temperature-dependent physical properties

JOURNAL OF THERMAL STRESSES , cilt.25, sa.6, ss.559-572, 2002 (SCI-Expanded)

Limit angular velocities of variable thickness rotating disks

Eraslan A., Argeso H.

INTERNATIONAL JOURNAL OF SOLIDS AND STRUCTURES , cilt.39, sa.12, ss.3109-3130, 2002 (SCI-Expanded)

Thermal stresses in elastic-plastic tubes with temperature-dependent mechanical and thermal properties

Orcan Y., Eraslan A.

JOURNAL OF THERMAL STRESSES , cilt.24, sa.11, ss.1097-1113, 2001 (SCI-Expanded)

COMPUTER ECONOMY AND ACCURACY OF THE METHOD OF LINES APPLIED TO LAMINAR FLAME PROBLEMS

ERASLAN A., BROWN R.

COMMUNICATIONS IN APPLIED NUMERICAL METHODS , cilt.5, sa.3, ss.181-190, 1989 (SCI-Expanded)

Diğer Dergilerde Yayınlanan Makaleler

Analytical solutions to orthotropic variable thickness disk problems

ERASLAN A. N., Kaya Y., VARLI E.

PAMUKKALE UNIVERSITY JOURNAL OF ENGINEERING SCIENCES-PAMUKKALE UNIVERSITESI MUHENDISLIK BILIMLERI DERGISI , cilt.22, sa.1, ss.24-30, 2016 (ESCI)

DEFORMATION ANALYSIS OF TWO LAYER COMPOSITE TUBES UNDER CYCLIC LOADING OF EXTERNAL PRESSURE

Motameni A., ERASLAN A. N.

Journal of Basic and Applied Research International , 2016 (Hakemli Dergi)

Fracture and Fatigue Crack Growth Characterization of Conventional and Head Hardened Railway Rail Steels

Journal of Scientific and Engineering Research , 2016 (Hakemli Dergi)

Analytical and Numerical Solutions to a Rotating FGM Disk

ERASLAN A. N., ARSLAN E.

Journal of Multidisciplinary Engineering Science and Technology , cilt.2, sa.10, ss.2843-2850, 2015 (Hakemli Dergi)

Analytical Solutions To Elastic Functionally Graded Cylindrical And Spherical Pressure Vessels

Journal of Multidisciplinary Engineering Science and Technology , cilt.2, sa.10, ss.2686-2693, 2015 (Hakemli Dergi)

Analytical and Numerical Solutions to Rotating Variable Thickness Disks for a New Thickness Profile

ERASLAN A. N., Buşra Ç.

Journal of Multidisciplinary Engineering Science and Technology , cilt.2, sa.9, ss.2359-2364, 2015 (Hakemli Dergi)

Thermoelastic Stresses in a Rod Subjected to Periodic Boundary Condition An Analytical Treatment

Journal of Multidisciplinary Engineering Science and Technology , cilt.2, sa.9, ss.2438-2444, 2015 (Hakemli Dergi)

Stress analysis in strain hardening two layer composite tubes subjectto cyclic loading of internal pressure

ERASLAN A. N., KAYA KARALAR Y., YEDEKÇİ B.

International Journal of Advances in Applied Mathematics and Mechanics , cilt.3, sa.2, ss.65-76, 2015 (Hakemli Dergi)

Elastic Response of a Heat Generating Rod at a VariableGeneration Rate

ERASLAN A. N., VARLI E.

International Journal of Advances in Engineering Science and Technology , cilt.4, sa.2, ss.73-83, 2015 (Hakemli Dergi)

A COMPUTATIONAL MODEL FOR PARTIALLY PLASTIC STRESS ANALYSIS OF ORTHOTROPIC VARIABLE THICKNESS DISKS SUBJECTED TO EXTERNAL PRESSURE

Mathematical Sciences and Applications E-Notes , cilt.2, sa.1, ss.1-13, 2014 (Hakemli Dergi)

Analytical Solution of Nonlinear Strain Hardening PreheatedPressure Tube

ERASLAN A. N., ARGEŞO A. H.

Turkish Journal of Engineering and Environmental Sicences , 2008 (Hakemli Dergi)

Computer Solutions of Plane Strain Axisymmetric Thermomechanical Problems

Turkish Journal of Engineering and Environmental Sciences , 2005 (Hakemli Dergi)

A Class of Nonisothermal Variable Thickness Rotating Disk Problems Solved by Hypergeometric Functions

ERASLAN A. N.

Turkish Journal of Engineering and Environmental Sciences , 2005 (Hakemli Dergi)

Yielding and Elastoplastic Deformation of Annular Disks of a Parabolic Section Subject to External Compression

AKGÜL F., ERASLAN A. N.

Turkish Journal of Engineering and Environmental Sciences , cilt.29, sa.1, ss.51-60, 2005 (Scopus)

Deformation Analysis of Elastic-Plastic Two Layer Tubes Subject to Pressure: an Analytical Approach