Pullback mode dragline stripping in dipping coal seam


Erdem B., Duran Z., Celebi N.

MINERAL RESOURCES ENGINEERING, cilt.11, sa.1, ss.17-34, 2002 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 11 Sayı: 1
  • Basım Tarihi: 2002
  • Doi Numarası: 10.1142/s0950609802000859
  • Dergi Adı: MINERAL RESOURCES ENGINEERING
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.17-34
  • Orta Doğu Teknik Üniversitesi Adresli: Hayır

Özet

This study presents the results of a computer-based model developed for analysing the pit geometry formed when a dragline operates in pullback mode. Basically, three spoiling procedures are modelled for a flat or an inclined coal seam. The normal operation model explores the conditions for dragline employment with a flat coal seam. Inclined model on the other hand, is divided into two parts: the uphill operation model where the dragline spoils uphill and the downhill model where the dragline spoils downhill. Two spoiling arrangements axe embedded into pullback model: waste is placed into the room near the set on which the dragline is located (DNS arrangement) or into the room near the set the dragline excavates (DND arrangement). Waste dug from key cut is placed on three main points: at the toe of previous spoil pile (distant), at the toe of coal seam (near) and within adjacent empty pit (middle). The pullback model also studies geometrical requirements on the spoil side.