Akademik Veri Yönetim Sistemi
APPLIED THERMAL ENGINEERING, cilt.219, 2023 (SCI-Expanded)
With the rapid development in the electronics industry, the thermal management of high power density elec-tronic products (HPDEPs) has become very important and requires innovative heat removal technologies. In this study, an integrated heat sink (IHS) fabricated by combining aluminum foam and pin-finned heat sink config-urations that are frequently used in the cooling of electronic products has been proposed as an effective solution for the thermal management of HPDEPs. The heat removal and pressure drop characteristics of the IHS were numerically investigated for its various design conditions such as the length/height ratio (L/H), fin profile, fin/ foam height ratio (Hfin/Hfoam), and heat sink/fin volume ratio (Vhs/Vf) over the range of Reynolds (ReDh) number from 500 to 3500 by using the COMSOL Multiphysics v5.4. Before the numerical study was performed, to verify the outcomes of the developed simulation models, some of the IHS subjected to the numerical study were fabricated and their pressure drop and heat removal performances were experimentally examined in the range of ReDh from 596 to 3551. As a result of the study, it was found that the thermal contact resistance (TCR) between the IHS and the heated surface has a greater effect on the Nusselt (Nu) number compared to the TCR between the solid fins and aluminum foam. The in-line or staggered arrangement of pin fins inside the aluminum foam did not lead to any significant difference in the overall performance of investigated IHS. For all the IHS examined, an increase in ReDh results in a similar increase in the Nu and Delta P along the flow direction. In general, the most efficient IHS among the investigated ones in terms of the Hfin/Hfoam ratio is the IHS with half-length fins, Hfin/ Hfoam = 15/30. Average values of thermal performance factor (n) of the IHS with Hfin/Hfoam ratio of 15/30 in in -line and staggered arrangement over the ReDh number studied are 1.3 and 1.25 times higher relative to IHS with Hfin/Hfoam ratio of 30/15. For a fixed number of fins, eta of the IHS with fins of 4 mm diameter is superior up to ReDh = 2000, after which, the situation varies in favor of the 8 mm solid finned aluminum foam heat sink. Increasing the fin diameter from 4 mm to 12 mm in both fin configurations worsens the average value of n by 10%. For a constant fin diameter, IHSs with 9 fins in in-line and 8 fins in staggered configuration have the highest n when the ReDh is greater than 2500 and 2000, respectively. Among the fin profiles examined, the IHS with elliptical fins is found to have the highest eta, with a value of 1.24, at ReDh = 3500.