Characterization of phase properties and deformation in ferritic-austenitic duplex stainless steels by nanoindentation and finite element method


Schwarm S. C., Kolli R. P., Aydogan E., Mburu S., Ankem S.

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, cilt.680, ss.359-367, 2017 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 680
  • Basım Tarihi: 2017
  • Doi Numarası: 10.1016/j.msea.2016.10.116
  • Dergi Adı: MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.359-367
  • Anahtar Kelimeler: Steel, Micromechanics, EBSD, Nanoindentation, Finite element method, MICROPILLAR COMPRESSION, MECHANICAL-PROPERTIES, PLASTIC PROPERTIES, FAILURE MODES, INDENTATION, PREDICTION, BEHAVIOR, EVOLUTION, DUCTILITY, HARDNESS
  • Orta Doğu Teknik Üniversitesi Adresli: Hayır

Özet

The phase properties and deformation behavior of the delta-ferrite and gamma-austenite phases of CF-3 and CF-8 cast duplex stainless steels were characterized by nanoindentation and microstructure-based finite element method (FEM) models. The elastic modulus of each phase was evaluated and the results indicate that the mean elastic modulus of the delta-ferrite phase is greater than that of the gamma-austenite phase, and the mean nanoindentation hardness values of each phase are approximately the same. The elastic FEM model results illustrate that greater von Mises stresses are located within the delta-ferrite phase, while greater von Mises strains are located in the gamma-austenite phase in response to elastic deformation. The elastic moduli calculated by FEM agree closely with those measured by tensile testing. The plastically deformed specimens exhibit an increase in misorientation, deformed grains, and subgrain structure formation as measured by electron backscatter diffraction (EBSD).