Design and fabrication of RF MEMS switches and instrumentation for performance evaluation

Thesis Type: Postgraduate

Institution Of The Thesis: Orta Doğu Teknik Üniversitesi, Faculty of Engineering, Department of Electrical and Electronics Engineering, Turkey

Approval Date: 2007




This thesis presents the RF and mechanical design of a metal-to-metal contact RF MEMS switch. Metal-to-metal contact RF MEMS switches are especially preferred in low frequency bands where capacitive switches suffer from isolation due to the limited reactance. Frequency band of operation of the designed switch is from DC to beyond X-band. Measured insertion loss of the structure is less than 0.2 dB, return loss is better than 30 dB, and isolation is better than 20 dB up to 20 GHz. Isolation is greater than 25 dB below 10 GHz. Hence, for wideband applications, this switch offers very low loss and high isolation. Time domain measurement is necessary for the investigation of the dynamic behavior of the devices, determination of the ‘pull in’ and ‘pull out’ voltages of the membranes, switching time and power handling of the devices. Also, failure and degradation of the switches can be monitored using the time domain setup. For these purposes a time domain setup is constructed. Moreover, failure mechanisms of the RF MEMS devices are investigated and a power electronic circuitry is constructed for the biasing of RF MEMS switches. Advantage of the biasing circuitry over the direct DC biasing is the multi-shape, high voltage output waveform capability. Lifetimes of the RF MEMS devices are investigated under different bias configurations. Finally, for measurement of complicated RF MEMS structures composed of large number of switches, a bias waveform distribution network is constructed where conventional systems are not adequate because of the high voltage levels. By this way, the necessary instrumentation is completed for controlling a large scale RF MEMS system.